Fotopast

720p@30fps | IP68 | Černá IR | Noční vidění | Úhel záběru: 55 ° | Pohybový senzor | Úhel detekce: 55 ° | Rozsah detekce: 25 m | Velikost obrazovky: 5 " | LCD obrazovka | Vícebarevné

Set the switch to setup
press menu.
Use up and down to scroll through the main menu.
Press ok to enter a certain menu.
Use left and right to change the value of the particular option.

This option allows you to give a camera aunique name so you can keep multiple camera's apart.

- Set the switch to setup (middle position)
- Press menu
- Use up and down to go to camera mode
- use left and right to change it to video if needed.
- Press down to set the clock. press enter to go into the date and time menu.
- Exit this menu and go to video size and select the resolution you want (1280x720 is the highest resolution)
- The next option is the video length. How long do you want it to record after a detection.
- Timelapse is an option that will have the camera take picture every 5 minutes (or 10, 15, 20 etc) and then stitches it into a video.
- PIR trigger: here you can set the sensitivity of the motion detection.
- PIR interval sets how often you want to scan with motion detection.
- Camera position is only a tag you can give your camera if you have more than one camera (camera 1 , camera 2 etc)

Difference between photo sizes: the resolution of the photo or video

Taking multiple photo's in rapid succession

Lower resolution means lower quality but you can store more video on your memory card, We recommend 1280x720 for best results

PIR is the motion detection. Turn it on to make the camera record when it sees motion

mode is photo or video (do you want it to record a photo, video or both?)

This is for manual recording. typically this is not used.

to turn the camera on and off

that's up to you. there is no right or wrong.

timelapse is a mode that takes pictures at certain intervals. Afterwards you can play this as a video. it looks like it is fast forwarded.

high is sensitive: it will respond to smaller movements.

how often do you want it to scan for movement.

It's the name of the camera, it is easier to keep multiple camera's apart.

Sometimes the IR filter is in front of the lens, when the camera is turned off. The camera is not faulty. When the camera is on, it will fix itself to the right place in front of the lens.